Honda Civic manuals

Honda Civic Service Manual: Rear Speaker Removal, Installation, and Test (2-door)

Honda Civic Service Manual / Body / Doors and Enclosures / Doors / Rear Speaker Removal, Installation, and Test (2-door)

013100 LEFT REAR

0131A8 RIGHT REAR

Removal

NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. Both Quarter Pillar Trims

1.

Remove the cap (A) and the clip (B).

2.

The left side is shown; repeat on the right side.

3.

Lower the coat hanger hook (A), then remove the screw (B).

4.

The left side is shown; repeat on the right side.

5.

Pull out the quarter pillar trim (A) to release the clips.

6.

Remove the quarter pillar trim.

NOTE: The rear clip (B) will stay in the body.

7.

The left side is shown; repeat on the right side.

8.

Remove the rear clip (A).

9.

The left side is shown; repeat on the right side.
2. Rear Shelf Trim

1.

Fold down the seat-back(s).

2.

From the trunk compartment, disconnect the connector (A).

3.

From the trunk compartment, detach the clips (A).

4.

Release the hooks (A).

5.

Pull out both rear seat belts (A) and the rear center seat belt (B) through the slits in the rear shelf trim (C), then remove the rear shelf trim.
3. Rear Speaker

1.

Remove the screw. Remove the rear speaker (A) by tilting it forward to release the clips (B).

2.

Disconnect the connector.

Test

1. Rear Speaker - Test

1.

Measure the resistance between terminals No. 1 and No. 2. There should be about 4 ?.

2.

If the resistance is not as specified, replace the rear speaker (A).

Installation

NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. Rear Speaker

mmmmwzzm.mwn

1.

Connect the connector.

2.

Install the rear speaker (A).
2. Rear Shelf Trim

1.

Slip the rear seat belts (A) and the rear center seat belt (B) through the slits in the rear shelf trim (C).

2.

Install the hooks (A).

3.

Install the clips (A).

4.

From the trunk compartment, connect the connector (A).

5.

Raise the seat-back(s).
3. Both Quarter Pillar Trims

1.

Install the new rear clip (A) to the quarter pillar trim (B).

2.

Fit the clips into the holes in the quarter pillar.

3.

Lightly push the quarter pillar trim (A) into place, then install the trim.

NOTE:

Make sure the side curtain airbag is not tucked under the clips or the ribs.

Do not push too hard on the quarter pillar trim. If you push too hard, the clip will be damaged, and it will not hold the trim properly.

Gently tug on the quarter pillar trim to verify that all clips are securely fastened.

4.

Install the screw (A).

5.

Install the clip (A) and the cap (B).
Rear Seat-Back Removal and Installation - Split Fold Down type (4-door)
Removal 1. Right Rear Seat-Back - Split Fold Down 1. Remove the ...

Rear Window Removal and Installation (4-door except Natural Gas models)
832120 Removal 1. Rear Seat Cushion 1. Remove the bolt (A) ...

See also:

Honda Civic Owners Manual. To Play Bluetooth’ Audio Files
1. Make sure that your phone is paired and connected to the system. Phone Setup 2. Select the Bluetooth’ Audio mode. If the phone is not recognized, another HFLcompatible phone, which is not compatible for Bluetooth’ Audio, may already be connected. To pause or resume a file Select ...

© 2016-2025 Copyright www.hocivic.com

0.0283