Honda Civic Service Manual: Rear Speaker Removal, Installation, and Test (2-door)
013100 LEFT REAR
0131A8 RIGHT REAR
Removal
|
NOTE: SRS components are located in this area. Review the SRS component
locations and the precautions and procedures before doing repairs or service.
|
| 1. |
Both Quarter Pillar Trims |
|
|
|
1.
|
Remove the cap (A) and the clip (B).
|
|
2.
|
The left side is shown; repeat on the right side.
|
|
|
|
|
3.
|
Lower the coat hanger hook (A), then remove the screw (B).
|
|
4.
|
The left side is shown; repeat on the right side.
|
|
|
|
|
5.
|
Pull out the quarter pillar trim (A) to release the clips.
|
|
6.
|
Remove the quarter pillar trim.
|
|
NOTE: The rear clip (B) will stay in the body.
|
|
7.
|
The left side is shown; repeat on the right side.
|
|
|
|
|
8.
|
Remove the rear clip (A).
|
|
9.
|
The left side is shown; repeat on the right side.
|
|
|
|
|
1.
|
Fold down the seat-back(s).
|
|
2.
|
From the trunk compartment, disconnect the connector (A).
|
|
|
|
|
3.
|
From the trunk compartment, detach the clips (A).
|
|
|
|
|
4.
|
Release the hooks (A).
|
|
|
|
|
5.
|
Pull out both rear seat belts (A) and the rear center seat belt
(B) through the slits in the rear shelf trim (C), then remove the
rear shelf trim.
|
|
|
|
|
1.
|
Remove the screw. Remove the rear speaker (A) by tilting it forward
to release the clips (B).
|
|
2.
|
Disconnect the connector.
|
|
Test
|
|
|
1.
|
Measure the resistance between terminals No. 1 and No. 2. There
should be about 4 ?.
|
|
2.
|
If the resistance is not as specified, replace the rear speaker
(A).
|
|
Installation
|
NOTE: SRS components are located in this area. Review the SRS component
locations and the precautions and procedures before doing repairs or service.
|
|
 mmmmwzzm.mwn
|
|
1.
|
Connect the connector.
|
|
2.
|
Install the rear speaker (A).
|
|
|
|
|
1.
|
Slip the rear seat belts (A) and the rear center seat belt (B)
through the slits in the rear shelf trim (C).
|
|
|
|
|
2.
|
Install the hooks (A).
|
|
|
|
|
3.
|
Install the clips (A).
|
|
|
|
|
4.
|
From the trunk compartment, connect the connector (A).
|
|
5.
|
Raise the seat-back(s).
|
|
| 3. |
Both Quarter Pillar Trims |
|
|
|
1.
|
Install the new rear clip (A) to the quarter pillar trim (B).
|
|
|
|
|
2.
|
Fit the clips into the holes in the quarter pillar.
|
|
3.
|
Lightly push the quarter pillar trim (A) into place, then install
the trim.
|
|
NOTE:
|
|
|
Make sure the side curtain airbag is not tucked
under the clips or the ribs.
|
|
|
|
Do not push too hard on the quarter pillar trim.
If you push too hard, the clip will be damaged,
and it will not hold the trim properly.
|
|
|
|
Gently tug on the quarter pillar trim to verify
that all clips are securely fastened.
|
|
|
|
|
|
|
4.
|
Install the screw (A).
|
|
|
|
|
5.
|
Install the clip (A) and the cap (B).
|
|
1.
Dashboard Center Pocket
1.
Remove the screws (A).
...
013100 LEFT REAR
0131A8 RIGHT REAR
Removal
1.
Rear Seat Cushion
1.
Remove the bolt (A) securing the rear ...
Audio-Navigation Unit Removal and Installation ('13)
Rear Speaker Removal, Installation, and Test (Natural Gas models)