Honda Civic manuals

Honda Civic Service Manual: Front Fog Light Bulb Removal and Installation ('13-'14: 4-door)

Honda Civic Service Manual / Body / Body Electrical / Lighting / Bulbs / Front Fog Light Bulb Removal and Installation ('13-'14: 4-door)

1. Front Fog Light Trim

Except Si model

Si model

1.

Remove the front fog light trim (A).
2. Front Fog Light

Except Si model

Si model

1.

Remove the front fog light (A).

2.

Disconnect the connector.
3. Front Fog Light Bulb

Except Si model

Si model

1.

Turn the bulb (A) 45 ° counterclockwise to remove it from the housing.

1. Front Fog Light Bulb

Except Si model

Si model

1.

Turn the bulb (A) 45 ° clockwise to install it to the housing.
2. Front Fog Light

Except Si model

Si model

1.

Connect the connector.

2.

Install the front fog light (A).
3. Front Fog Light Trim

Except Si model

Si model

1.

Install the front fog light trim (A).
4. Front Fog Light - Adjustment

Before adjusting the front fog light:

Park the vehicle on a level surface.

Make sure the tire pressures are correct

The driver or someone who weights the same should sit in the driver's seat (or an equivalent amount of weight).

Unload the vehicle.

The front fog lights should aim down slightly. To check for proper adjustment:

1.

Park the vehicle in front of a wall or a screen (A).

2.

Turn the front fog lights on.

3.

Determine if the front fog lights are aimed properly:

Measure the height of the front fog lights (B).

On the screen or wall, mark the height of the front fog lights with a piece of tape (C).

With the vehicle parked 3 m (9.8 ft) from the screen, the top of the front fog light beam should be 4.5 cm (1.77 in) (D) below the tape mark.

Except Si model

Si model

4.

Adjust the front fog lights by turning the adjuster (A).
Bulbs
...

Right Headlight (Low Beam) Bulb Removal and Installation ('12-'13)
7121E7 RIGHT 1. Washer Filler Neck 1. Remove the washer filler neck (A) from the washer reservoir. ...

See also:

Honda Civic Owners Manual. Installing a LATCH-Compatible Child Seat
A LATCH-compatible child seat can be installed in either of the two outer rear seats. A child seat is attached to the lower anchors with either the rigid or flexible type of connectors. 1. Locate the lower anchors under the marks. 2. Place the child seat on the vehicle seat then a ...

© 2016-2026 Copyright www.hocivic.com

0.0085