Honda Civic manuals

Honda Civic Service Manual: Input Shaft (Mainshaft) Speed Sensor Removal and Installation (A/T)

Honda Civic Service Manual / Powertrain / Internal Combustion Powertrain Control / Transmission Control / Input Shaft (Mainshaft) Speed Sensor Removal and Installation (A/T)

2181D8

Removal

1. Air Cleaner


1.

Disconnect the intake air duct (A).

2.

Remove the air cleaner (B).

3.

Remove the harness clamp (C).

2. Input Shaft (Mainshaft) Speed Sensor

1.

Disconnect the connector (A).

2.

Remove the input shaft (mainshaft) speed sensor (A) with the O-ring (B).

Installation

1. Input Shaft (Mainshaft) Speed Sensor

1.

Install the input shaft (mainshaft) speed sensor (A) using a new O-ring (B).

2.

Check the connector (A) for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.

2. Air Cleaner


1.

Install the harness clamp (A).

2.

Install the air cleaner (B).

3.

Connect the intake air duct (C).

Shift Lock Unit Removal and Installation (A/T, CVT)
7431A1 NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*) when you disassemble it. 1. Center Console ...

Output Shaft (Countershaft) Speed Sensor Removal and Installation (A/T)
2181D9 Removal 1. Air Cleaner 1. Disconnect the intake air duct (A). ...

See also:

Honda Civic Owners Manual. Adjusting the Shoulder Anchor
The front seats have adjustable shoulder anchors to accommodate taller and shorter occupants. 1. Move the anchor up and down while pulling the release outward. 2. Position the anchor so that the belt rests across the center of your chest and over your shoulder. Adjusting the Shoulder ...

© 2016-2026 Copyright www.hocivic.com

0.0242