Honda Civic manuals

Honda Civic Service Manual: Output Shaft (Countershaft) Speed Sensor Removal and Installation (A/T)

Honda Civic Service Manual / Powertrain / Internal Combustion Powertrain Control / Transmission Control / Output Shaft (Countershaft) Speed Sensor Removal and Installation (A/T)

2181D9

Removal

1. Air Cleaner


1.

Disconnect the intake air duct (A).


2.

Remove the air cleaner (B).


3.

Remove the harness clamp (C).


2. Output Shaft (Countershaft) Speed Sensor

1.

Disconnect the connector (A).


2.

Remove the output shaft (countershaft) speed sensor (A) with the O-ring (B).


Installation

1. Output Shaft (Countershaft) Speed Sensor

1.

Install the output shaft (countershaft) speed sensor (A) using a new O-ring (B).


2.

Check the connector (A) for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.


2. Air Cleaner


1.

Install the harness clamp (A).


2.

Install the air cleaner (B).


3.

Connect the intake air duct (C).


Input Shaft (Mainshaft) Speed Sensor Removal and Installation (A/T)
2181D8 Removal 1. Air Cleaner 1. Disconnect the intake air duct (A). ...

Output Shaft (Countershaft) Speed Sensor Removal and Installation (K24Z7)
2131J4 1. Vehicle Lift 1. Raise the vehicle on a lift, and make sure it is securely supported. ...

See also:

Honda Civic Service Manual. High Mount Brake Light Removal and Installation - Without Trunk Lid Spoiler (4-door except Natural Gas models)
Removal SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. 1. Rear Seat Cushion ...

© 2016-2024 Copyright www.hocivic.com

0.0167