Honda Civic Service Manual: Rear Seat Belt Removal and Installation (Except Natural Gas models)
865100 LEFT
866100 RIGHT
8551A8 LEFT
Removal
|
|
1.
|
Remove the bolt (A) securing the rear seat cushion (B).
|
|
|
|
2.
|
While pushing down the rear seat cushion (A), pull the seat hook
handles (B) to release the hooks (C).
|
|
3.
|
Remove the rear seat cushion.
|
|
2. |
Both Rear Seat Side Bolsters |
|
|
1.
|
Remove the bolt (A) securing the rear seat side bolster (B).
|
|
2.
|
The left side is shown; repeat on the right side.
|
|
|
|
3.
|
Remove the rear seat side bolster (A).
|
|
4.
|
The left side is shown; repeat on the right side.
|
|
3. |
Both Rear Door Opening Seals as Needed |
|
|
1.
|
Remove the rear door opening seal (A) as needed.
|
|
2.
|
The left side is shown; repeat on the right side.
|
|
|
|
1.
|
Pull out the C-pillar trim (A) to release the clips.
|
|
2.
|
Remove the C-pillar trim.
|
|
NOTE: The front clip (B) will stay in the body.
|
|
3.
|
The left side is shown; repeat on the right side.
|
|
|
|
4.
|
Remove the front clip (A).
|
|
5.
|
The left side is shown; repeat on the right side.
|
|
|
|
1.
|
Fold down the seat-back(s).
|
|
2.
|
From the trunk compartment, disconnect the connector (A).
|
|
|
|
3.
|
From the trunk compartment, detach the clips (A).
|
|
|
|
4.
|
Release the hooks (A).
|
|
|
|
5.
|
Pull out both rear seat belts (A) and the rear center seat belt
(B) through the slits in the rear shelf trim (C), then remove the
rear shelf trim.
|
|
6. |
Rear Seat belt Retractor |
|
|
1.
|
Remove both lower anchor bolts (A).
|
|
|
|
2.
|
Rear center seat belt retractor: Remove the left seat belt buckle
bolt (A).
|
|
Left
Center
Right
|
|
3.
|
Remove the seat belt retractors (A).
|
|
Installation
1. |
Rear Seat belt Retractor |
Left
7/i5-2n
Center
Right
nm
|
|
1.
|
Install the seat belt retractors (A).
|
|
|
|
2.
|
Rear center seat belt retractor: Install the left seat belt buckle
bolt (A).
|
|
32
|
|
3.
|
Install both lower anchor bolts (A).
|
|
|
|
1.
|
Slip the rear seat belts (A) and the rear center seat belt (B)
through the slits in the rear shelf trim (C).
|
|
|
|
2.
|
Install the hooks (A).
|
|
|
|
3.
|
Install the clips (A).
|
|
|
|
4.
|
From the trunk compartment, connect the connector (A).
|
|
5.
|
Raise the seat-back(s).
|
|
|
|
1.
|
Install the new front clip (A) to the C-pillar trim (B).
|
|
|
|
2.
|
Install the C-pillar trim (A).
|
|
NOTE:
|
|
|
Make sure the side curtain airbag is not tucked
under the clips or the ribs.
|
|
|
|
Do not push too hard on the C-pillar trim. If
you push too hard, the clip will be damaged, and
it will not hold the trim properly.
|
|
|
|
Gently tug on the C-pillar trim to verify that
all clips are securely fastened.
|
|
|
|
3.
|
The left side is shown; repeat on the right side.
|
|
4. |
Both Rear Door Opening Seals as Needed |
|
|
1.
|
Install the rear door opening seal (A).
|
|
2.
|
The left side is shown; repeat on the right side.
|
|
5. |
Both Rear Seat Side Bolsters |
|
|
1.
|
Install the rear seat side bolster (A).
|
|
2.
|
The left side is shown; repeat on the right side.
|
|
mmmmlnss
|
|
3.
|
Install the bolt (A) securing the rear seat side bolster (B).
|
|
4.
|
The left side is shown; repeat on the right side.
|
|
|
|
1.
|
Install the hooks (A) to the rear seat cushion clips (B).
|
|
|
|
2.
|
Install the bolt (A) securing the rear seat cushion (B).
|
|
8551A9 RIGHT
Removal
1.
Rear Seat Cushion
1.
Remove the bolt (A) securing the rear seat cushion (B).
...
8541A1 LEFT
8541A2 RIGHT
SRS components are located in this area. Review the SRS component locations
and the precautions and procedures before doing repairs or service.
...
See also:
Honda Civic Owners Manual. Automatic Lighting Off Feature
The headlights, all other exterior lights, and the instrument panel lights
turn off 15
seconds after you remove the key or set the power mode to VEHICLE OFF (LOCK),
take the remote with you, and close the driver’s door.
You can change the headlight auto off timer setting.
Customized Features ...