Honda Civic manuals

Honda Civic Service Manual: ODS Unit Operation Check (KA KC KL models)

Procedure

1. After Replacing Front Passenger's Seat Component(s)

After Replacing Front Passenger's Seat Component(s)

NOTE: Check the ODS unit operation after any of these actions:

Front passenger's seat component(s) replacement (except ODS unit and/or front passenger's weight sensor).

SRS unit replacement.

Remove the front passenger's weight sensor(s).

After a vehicle collision.

2. Test Drive

1.

Drive the vehicle, accelerate to 22 mph (36 km/h), then stop on level ground.

3. HDS DLC - Connection

1.

Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.

2.

Turn the ignition switch to ON (II).

3.

Make sure the HDS communicates with the vehicle. If it does not communicate, go to the DLC circuit troubleshooting.

4. Pre-Operation Check Set-Up

Pre-Operation Check Set-Up

Make sure all the components of the front passenger's seat are correctly installed.

Position the front passenger's seat all the way rearward, and adjust the seat-back to the forward most position. Do not move the seat from this position until the output check is completed.

Make sure nothing is on the front passenger's seat, including aftermarket seat covers or mats.

Make sure there is nothing in the front passenger's seat-back pocket.

Keep the windows and the moonroof closed.

Do all initialization procedures, except test-driving, in the service bay.

Make sure the vehicle is on level ground.

Dehumidify inside of the vehicle with A/C.

Do not touch the front passenger's seat during the operation check.

Do not expose the front passenger's seat to sudden temperature changes.

Make sure all aftermarket devices such as amplifiers, fluorescent light, air purifiers, CB or HAM radios, etc. are turned off.

1.

From the HDS Main Menu, select SRS, then Inspection. In the Inspection Menu, select AFTER REPLACING FRONT PASSENGER'S SEAT COMPONENT(S). Follow the prompts until the ODS unit operation check has been completed.

2.

Turn the ignition switch to LOCK (0).

Front Passenger's Weight Sensor Unit Removal and Installation ('13-'14: 4-door)
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. 1. Battery Term ...

ODS Unit Removal and Installation (KA KC KL models)
7521B5 Removal NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. ...

See also:

Honda Civic Owners Manual. Locking a Door Without Using a Key
Locking the driver’s door Push the lock tab forward or push the master door lock switch in the lock direction , and close the door. Locking the passenger’s doors Push the lock tab forward  and close the door. Lockout prevention system Models without smart entry system The doo ...

© 2016-2024 Copyright www.hocivic.com

0.0075