
Fig. 186 Changing a tyre: loosening the wheel nuts with the wheel wrench.

Fig. 187 Changing a tyre: tyre valve position 1 and the correct locations for the anti-theft wheel
locking bolt, marked 2 and 3.
When loosening the wheel nuts on your Seat Ibiza, use only the wheel wrench supplied with the vehicle. This tool is intended for the original wheel fasteners and allows the necessary force to be applied while maintaining proper engagement with the nuts.
Before lifting the vehicle with the jack, loosen each wheel nut by approximately one complete turn. The wheel must remain firmly in contact with the ground during this initial operation, as this prevents it from rotating while the nuts are being loosened. Do not completely remove the wheel nuts until the vehicle has been safely raised and supported in accordance with the jacking instructions.
If a wheel nut is particularly tight and cannot be loosened using normal hand pressure, carefully apply additional force by pressing down on the end of the wheel wrench with your foot. Make sure the wrench is fully seated on the nut before attempting this, and apply pressure gradually rather than using sudden or uncontrolled movements.
When using your foot to loosen a stubborn wheel nut, hold on to the vehicle for support and maintain a stable position. Take particular care to avoid slipping or losing your balance, especially if the ground is wet, uneven or slippery. The vehicle must be securely parked on a firm, level surface before beginning any wheel-changing procedure.
Loosening wheel nuts
Important information about wheel nuts
The wheels and fastening nuts originally installed on the Seat Ibiza are selected to work together as a matched assembly. Their dimensions, seating surfaces and other design characteristics are intended to provide a secure connection between the wheel and the hub. If the original rims are replaced with different ones, the replacement wheels must be fitted using wheel nuts of the correct length and with the appropriate head and seating design.
Using correctly matched wheel fasteners ensures that the wheels can be securely attached to the vehicle and helps maintain the proper operation of the braking system. Incorrect fasteners may not seat against the wheel as intended, even if they appear to fit the threaded holes. For this reason, compatibility must be established before installing different rims or wheel nuts.
Wheel nuts should not automatically be considered interchangeable simply because they come from another SEAT vehicle or even another Seat Ibiza of the same model. Differences in wheel design, equipment or fastening specifications can make otherwise similar-looking nuts unsuitable. Always use fasteners that are specifically compatible with the rims installed on the vehicle.
On wheels equipped with integral hubcaps, the anti-theft wheel locking bolt must be installed in one of the designated positions shown in ››› Fig. 187 2 or 3, using the tyre valve marked 1 as the reference point. This arrangement provides the clearance and alignment needed for the hubcap to fit correctly. If the locking bolt is installed in a different position, the hubcap may not be possible to mount properly.
WARNING
Wheel nuts that have not been installed or tightened correctly may loosen while the Seat Ibiza is being
driven. A loose wheel can seriously affect vehicle stability and steering control, potentially resulting in
an accident, severe injuries or complete loss of control. Always observe the following precautions when
removing or installing wheels.
Wheel nut caps
Raise the vehicleHonda Civic Owners Manual. If the Smart Entry Remote Battery is
Weak
Models with smart entry system
If the beeper sounds, the To Start, Hold Remote Near Start Button message
appears on the driver information interface, the ENGINE START/STOP button
flashes, and the engine won't start. Start the engine as follows:
Touch the center of the ENGINE START/
...