Honda Civic Service Manual: Driver's Vent Removal and Installation

Removal
| 1. |
Battery Terminal (SRS) - Disconnection |
|

|
|
1.
|
Make sure the ignition switch is in LOCK (0).
|
|
2.
|
Disconnect and isolate the negative cable and battery sensor
(A) from the battery (B).
|
|
NOTE: Always disconnect the negative side first.
|
|
3.
|
Disconnect the positive cable (C) from the battery.
|
|
4.
|
Wait at least 3 minutes before starting work.
|
|
| 2. |
Driver's Dashboard Lower Cover |
|

|
|
1.
|
Remove the driver's dashboard lower cover (A).
|
|
| 3. |
Dashboard Subdisplay Visor |
|

|
|
1.
|
Remove the dashboard subdisplay visor (A).
|
|
|

|
|
1.
|
Remove the driver's outer vent (A).
|
|
|

|
|
1.
|
Remove the driver's inner vent (A).
|
|

Installation
|

|
|
1.
|
Install the driver's inner vent (A).
|
|
|

|
|
1.
|
Install the driver's outer vent (A).
|
|
| 3. |
Dashboard Subdisplay Visor |
|

|
|
1.
|
Install the dashboard subdisplay visor (A).
|
|
| 4. |
Driver's Dashboard Lower Cover |
|

|
|
1.
|
Install the driver's dashboard lower cover (A).
|
|
| 5. |
Battery Terminal (SRS) - Reconnection |
|
(o.2ao.sam.
|
|
NOTE: If the battery performs abnormally, test the battery.
|
|
1.
|
Clean the battery terminals.
|
|
2.
|
Connect the positive cable (A) to the battery (B).
|
|
NOTE: Always connect the positive side first.
|
|
3.
|
Connect the negative cable and battery sensor (C) to the battery.
|
|
4.
|
Apply multipurpose grease to the terminals to prevent corrosion.
|
|
1.
Dashboard Center Pocket
1.
Remove the screws (A).
...
8411E6 RIGHT CENTER
1.
Driver's Dashboard Lower Cover
1.
Remove the driver's dashboard lower co ...
See also:
Honda Civic Owners Manual. Precautions for Opening/Closing the Trunk
Opening the trunk
Open the trunk all the way.
If it is not fully opened, the trunk lid may begin to close under its
own weight.
Closing the trunk
Keep the trunk lid closed while driving to:
Avoid possible damage.
Prevent exhaust gas from leaking into the vehicle.
Exhaust Gas Haz ...