Seat Ibiza (6F) 2017-2026 Owner's Manual: Snow chains
Snow chains may only be fitted to the front wheels of the Seat Ibiza, including versions equipped with four-wheel
drive. This restriction must be observed regardless of the prevailing road conditions or the type of snow chains
being used. Snow chains provide additional traction on snow-covered or icy surfaces, but they must be compatible
with the vehicle's approved wheel and tyre specifications. Incorrect installation or the use of unsuitable
chains can damage the tyres, wheel rims and surrounding vehicle components, as well as adversely affect steering
and handling.
- After fitting snow chains, drive a short distance at low speed and then stop in a safe location to check
that they remain correctly positioned around the tyres. The chains should sit evenly on the tread and must
not be twisted, loose or displaced towards the sidewalls. If necessary, adjust their position or tension in
accordance with the snow chain manufacturer's installation instructions. This initial check is particularly
important because chains may settle into position during the first few metres of driving. Continue to
monitor their condition during use, especially if unusual noises or vibrations occur.
- Do not exceed a speed of 50 km/h (30 mph) when driving with snow chains. A lower speed may
be necessary depending on the road surface, weather conditions, traffic and the restrictions specified by
the chain manufacturer. Snow chains are intended to improve traction at relatively low speeds on slippery
surfaces, not to permit normal driving speeds in severe winter conditions. Accelerate gently, avoid abrupt
steering movements and allow additional distance for braking. Excessive speed can cause the chains to move
out of position, become damaged or strike components around the wheels.
- If the vehicle is at risk of becoming stuck in deep snow or on a particularly slippery surface despite
having snow chains fitted, it may be helpful to temporarily deactivate the traction control system (TCS)
through the relevant ESC controls, where this function is available. Traction control normally limits
excessive wheelspin, but in certain difficult conditions a limited amount of wheelspin may help the vehicle
regain movement. Only use this measure when necessary and restore the normal traction control setting once
the difficult section has been negotiated.
When correctly installed on suitable tyres, snow chains can improve both traction and braking performance
in winter conditions. They help the driven wheels obtain additional grip on snow and ice, making it
easier to move away from a standstill and maintain progress on slippery roads. Their additional grip can
also assist braking, although stopping distances may still be considerably longer than on a dry road.
The driver must continue to adapt speed and driving behaviour to the available traction.
For technical and safety reasons, snow chains are permitted only with specific wheel rim and tyre combinations
approved for the Seat Ibiza. The permitted combinations are shown in the following table. These restrictions
take account of the space available around the wheels and the need to prevent the chains from contacting the
suspension, bodywork, braking components or other parts of the vehicle during operation.
Before purchasing or installing snow chains, compare the tyre dimensions and wheel rim specifications fitted to
your vehicle with the approved combinations shown below. Do not assume that chains suitable for one tyre size
can also be used with another, even when the dimensions appear similar. The correct combination is essential for
maintaining adequate clearance while the wheels rotate and the suspension moves.
Remove any central wheel trims or hubcaps that could interfere with snow chain installation before fitting the
chains. These components may obstruct the correct positioning of the chains or become damaged if they come into
contact with the chain links or fastening mechanism. Store removed wheel trims securely so that they can be
refitted after the chains have been taken off. Make sure that the chains are correctly secured and that their
fastening components cannot strike the wheel rim or surrounding parts while driving.
WARNING
Using snow chains that are unsuitable for the vehicle, incorrectly sized or improperly installed can cause
serious accidents and substantial damage. Chains that become loose or displaced while driving may interfere
with wheel rotation, damage the tyres or strike nearby vehicle components. This can affect steering, braking
and vehicle stability, potentially resulting in a loss of control. Always confirm compatibility and correct
installation before driving with snow chains fitted.
- Use only snow chains that are suitable for the approved wheel and tyre combination fitted to your Seat
Ibiza. The chains must be of the correct dimensions and design and must provide the necessary clearance
from surrounding components. Do not install chains simply because they can be stretched around the tyre.
If compatibility is uncertain, consult an authorised SEAT Service centre or a qualified tyre specialist
before using them.
- Follow the installation, adjustment and removal instructions supplied by the snow chain manufacturer.
Different chain designs may use different fastening and tensioning systems, and correct installation is
essential for safe operation. Check that all locking mechanisms are properly engaged and that the chains
are evenly positioned around the tyres. After driving a short distance, inspect their seating and make
any adjustments required by the manufacturer's instructions.
- Never exceed the maximum permitted speed when driving with snow chains. Observe the vehicle's specified
limit of 50 km/h (30 mph) and any lower speed restriction imposed by the chain manufacturer or
applicable road regulations. Driving too quickly increases the forces acting on the chains and can cause
them to loosen, break or damage the wheels and tyres. Reduce speed further whenever road conditions,
visibility or available grip make this necessary.
- Before installing snow chains, verify that the wheel and tyre combination currently fitted to the vehicle
is included in the table of approved combinations. The relevant dimensions can also be checked against
the vehicle's technical documentation. Do not rely solely on the appearance of the wheels or on the
assumption that the original equipment has not been changed. If the fitted wheels or tyres differ from
the approved specifications, the chains must not be used unless their compatibility has been
confirmed.
NOTICE
- Remove snow chains as soon as they are no longer required and before continuing on roads that are free
from snow or ice. Driving with chains on a clear road surface can adversely affect steering, braking and
ride comfort. The chains may also damage the tyre tread and wear out rapidly because they are being used
against a hard surface rather than snow. Continued use under these conditions can place unnecessary
stress on the wheels and surrounding components. Stop in a safe location to remove the chains before
resuming normal driving.
- Snow chains can scratch or damage wheel rims if their metal components come into direct contact with the
rim surfaces. This is particularly relevant to alloy wheels and rims with decorative finishes. SEAT
recommends using snow chains with suitable protective coverings to reduce the likelihood of contact
damage. Protective coverings do not eliminate the need for correct installation, adequate clearance and
regular checks. If unusual scraping or knocking noises occur, stop safely and inspect the chains and
wheels before continuing.
The wheel nuts or bolts and wheel rims are designed to work together as a matched fastening assembly. Their
dimensions and contact surfaces must be compatible to ensure that the wheels are correctly ...
See also:
Honda Civic Owners Manual. Display Setup
You can change the brightness or color theme of the audio/information screen.
Changing the Screen Brightness
1. Select .
2. Select Settings.
3. Select System.
4. Select the Display tab.
5. Select Display Settings.
6. Select the setting you want.
7. Select OK.
Changing the Sc ...