
Fig. 167 Release lever in the driver's footwell
area.

Fig. 168 Lever under the bonnet.
Opening the bonnet
The bonnet of the Seat Ibiza is released using a lever located inside the passenger compartment, followed by a secondary release mechanism beneath the front edge of the bonnet. Both mechanisms must be operated before the bonnet can be raised fully. Make sure the vehicle has been prepared for engine compartment work before attempting to open it.
Before releasing the bonnet, check that both windscreen wiper arms are resting in their normal position against the windscreen. If the wiper arms have been raised away from the glass, return them carefully to their original position. Opening the bonnet while the wipers are raised may cause the bonnet to strike the wiper arms, potentially damaging the arms, their mounting points or the bonnet itself.
Closing the bonnet
Before closing the bonnet, check that no tools, cleaning materials or other objects have been left in the engine compartment. Make sure all filler caps and other components that were opened or removed during maintenance have been properly refitted. The bonnet support rod must also be returned to its storage position before the bonnet is lowered.
If the bonnet does not lock correctly after being released from the specified height, do not attempt to force it shut by pressing down on the outer panel. Applying pressure directly to the bonnet may deform the metal or damage the paintwork. Instead, open the bonnet again, check that nothing is obstructing the locking mechanism, and repeat the closing procedure by allowing it to drop from approximately 20 cm. Do not drive the vehicle until the bonnet is securely closed.
WARNING Always verify that the bonnet is completely closed and securely locked before driving your Seat Ibiza. A bonnet that is only partially latched may appear closed but can open unexpectedly while the vehicle is moving.
If the bonnet opens during driving, it may obstruct the driver's view of the road and cause a serious accident. Never begin a journey if the bonnet does not close correctly or if there is any doubt about the condition of its locking mechanism. Have the fault inspected and repaired before using the vehicle.
NOTICE In cold or snowy weather, ice and snow may accumulate between the bonnet and the windscreen, particularly around the bonnet hinges and the rear edge of the engine compartment opening. Before attempting to raise the bonnet, inspect these areas for frozen deposits or obstructions. Do not force the bonnet open if ice or compacted snow is preventing normal movement. Remove the obstruction carefully and make sure the bonnet can move freely to avoid damaging the hinges, body panels, paintwork or surrounding components.
NOTICE To prevent damage to the bonnet and windscreen wiper arms, only open the bonnet when the wipers are resting in their normal position against the windscreen. Raised wiper arms may interfere with the bonnet as it opens, potentially bending the arms, damaging their mounting mechanisms or marking the bonnet surface. Always check the wiper position before operating the bonnet release.
Preparing the vehicle for work in the
engine compartment
Fluids and consumablesHonda Civic Service Manual. Audio-Navigation Unit Removal and Installation ('13)
1.
Dashboard Center Pocket
1.
Remove the screws (A).
2.
Remove the dashboard center pocket (A).
...