Honda Civic Service Manual: Driver's Vent Removal and Installation
Removal
| 1. |
Battery Terminal (SRS) - Disconnection |
|
|
|
1.
|
Make sure the ignition switch is in LOCK (0).
|
|
2.
|
Disconnect and isolate the negative cable and battery sensor
(A) from the battery (B).
|
|
NOTE: Always disconnect the negative side first.
|
|
3.
|
Disconnect the positive cable (C) from the battery.
|
|
4.
|
Wait at least 3 minutes before starting work.
|
|
| 2. |
Driver's Dashboard Lower Cover |
|
|
|
1.
|
Remove the driver's dashboard lower cover (A).
|
|
| 3. |
Dashboard Subdisplay Visor |
|
|
|
1.
|
Remove the dashboard subdisplay visor (A).
|
|
|
|
|
1.
|
Remove the driver's outer vent (A).
|
|
|
|
|
1.
|
Remove the driver's inner vent (A).
|
|
Installation
|
|
|
1.
|
Install the driver's inner vent (A).
|
|
|
|
|
1.
|
Install the driver's outer vent (A).
|
|
| 3. |
Dashboard Subdisplay Visor |
|
|
|
1.
|
Install the dashboard subdisplay visor (A).
|
|
| 4. |
Driver's Dashboard Lower Cover |
|
|
|
1.
|
Install the driver's dashboard lower cover (A).
|
|
| 5. |
Battery Terminal (SRS) - Reconnection |
|
 (o.2ao.sam.
|
|
NOTE: If the battery performs abnormally, test the battery.
|
|
1.
|
Clean the battery terminals.
|
|
2.
|
Connect the positive cable (A) to the battery (B).
|
|
NOTE: Always connect the positive side first.
|
|
3.
|
Connect the negative cable and battery sensor (C) to the battery.
|
|
4.
|
Apply multipurpose grease to the terminals to prevent corrosion.
|
|
1.
Dashboard Center Pocket
1.
Remove the screws (A).
...
1.
Radiator Cap
1.
Wait until the engine is cool, then carefully remove the radiator
cap.
...
See also:
Honda Civic Owners Manual. When the System can be Used
The system can be used when the following conditions are met.
The lane in which you are driving has detectable lane markers on
both sides, and
your vehicle is in the center of the lane.
The vehicle speed is between 45 and 90 mph (72 and 145 km/h).
You are driving on a ...
Driver's Center Vent Removal and Installation ('13-'14)
Heater Outlet Removal and Installation (R18A9)