Commercialisation of finished products on the British market (England, Wales and Scotland):
The UKCA (UK Conformity Assessed) marking is a British conformity marking introduced for products placed on the market in Great Britain, comprising England, Wales and Scotland. It indicates that a product has been assessed against the applicable British regulatory requirements for the relevant product category. The marking applies to products covered by the corresponding legislation and is used to demonstrate conformity with the requirements governing their supply on the British market.
Depending on the type of product and the regulations applicable to it, UKCA marking may be required for certain finished products supplied with or installed in a Seat Ibiza. The conformity requirements concern the individual products and their relevant technical characteristics, rather than establishing a separate approval for every vehicle component regardless of its regulatory classification.
Importer:
Volkswagen Group United Kingdom Ltd.
Yeomans Drive, Blakelands
Milton Keynes, MK 14 5AN
United Kingdom
Vehicles placed on the British market by the importer identified above may contain finished products that fall within the scope of specific British product safety and conformity regulations. Depending on their design, function and intended use, these products must comply with the legislation applicable to their respective categories.
The following regulations are among those relevant to products that may be supplied as part of the vehicle or its associated equipment. Their applicability depends on the characteristics of the individual product and the legal requirements in force when it is placed on the market:
Note The original conformity information specifies that the relevant marking for medical devices would remain valid in the United Kingdom until 30 June 2023. This is a historical transitional date and should not be interpreted as confirmation of the current acceptance requirements for medical devices. The applicable rules depend on the product category, the relevant legislation and any subsequent regulatory amendments.
In accordance with the regulations identified above, the importer is responsible for ensuring that the relevant conformity obligations have been addressed before applicable finished products are placed on the British market. These obligations include verifying that the manufacturer has completed the necessary conformity assessment procedures and that the product meets the requirements applicable to its category.
The manufacturer must have carried out the corresponding conformity assessment, prepared the required technical documentation and established that the product complies with the relevant market requirements. The technical documentation provides the basis for demonstrating conformity and may include information necessary to assess the product against the applicable safety and regulatory provisions.
Where required by the relevant legislation, the appropriate conformity marking and accompanying information must be provided. The responsibilities of the manufacturer and importer are determined by the applicable regulatory framework, including the requirements governing product identification, documentation and the demonstration of conformity.
Note The original transitional provisions stated that, until 31 December 2025, the British conformity marking could be provided on a label affixed to the product or included in the accompanying documentation, subject to the applicable conditions. This date reflects the information contained in the original vehicle documentation. As British product marking requirements and transitional arrangements may be amended, the current rules should be consulted when determining how conformity marking must be displayed on products placed on the market.
Return and scrapping of end-of-life vehiclesHonda Civic Service Manual. Hood Opener Cable Removal and Installation
8121C1
1.
Vehicle Lift
1.
Raise the vehicle on a lift, and make sure it is securely
supported.
2.
Front Wheel
...