Honda Civic manuals

Honda Civic Owners Manual: ACC with LSF Conditions and Limitations. To Adjust the Vehicle Speed

Honda Civic Owners Manual / Driving / When Driving / Adaptive Cruise Control (ACC) with Low Speed Follow (LSF) / ACC with LSF Conditions and Limitations. To Adjust the Vehicle Speed

ACC with LSF Conditions and Limitations

The system may automatically shut off and the ACC indicator will come on under certain conditions. Some examples of these conditions are listed below. Other conditions may reduce some of the ACC functions.

Environmental conditions

Roadway conditions

Vehicle conditions

ACC with LSF Conditions and Limitations

The radar sensor for ACC with LSF is shared with the collision mitigation braking systemTM (CMBSTM).

You can read about handling information for the camera equipped with this system.

Do not put a sticker on the radar sensor cover or replace the radar sensor cover.

Have your vehicle checked by a dealer if you find any unusual behavior of the system (e.g., the warning message appears too frequently).

If the front of the vehicle is impacted in any of the following situations, the radar sensor may not work properly. Have your vehicle checked by a dealer:

  •  The vehicle mounted onto a bump, curb, chock, embankment, etc.
  •  You drive the vehicle where the water is deep.
  •  Your vehicle has a frontal collision.

Detection limitations

To Adjust the Vehicle Speed

Increase or decrease the vehicle speed using the RES/+ or -/SET button on the steering wheel.

To Adjust the Vehicle Speed

To Adjust the Vehicle Speed

If a vehicle detected ahead is going at a speed slower than your increased set speed, ACC with LSF may not accelerate your vehicle. This is to maintain the set interval between your vehicle and the vehicle ahead.

When in Operation
There is a vehicle ahead ACC with LSF monitors if a vehicle ahead of you enters the ACC with LSF range. If a vehicle is detected doing so, the ACC with LSF system maintains or decelerates your ...

To Set or Change Following Interval. To Cancel
To Set or Change Following Interval Press the (interval) button to change the ACC with LSF following interval. Each time you press the button, the followinginterval (the interval behind a ...

See also:

. Removing and Reinstalling the Front Head Restraints
Front head restraints can be removed for cleaning or repair. To remove a head restraint: Pull the restraint up as far as it will go. Then push the release button, and pull the restraint up and out. To reinstall a head restraint: Insert the legs back in place, then adjust the head restraint to ...

Nissan Kicks - OM - Seats - Wheels and tires - Audio system -
© 2016-2026 Copyright www.hocivic.com

0.0226