Honda Civic Service Manual: Shift Solenoid Wire Harness Removal and Installation (A/T)

1.

Raise the vehicle on a lift, and make sure it is securely supported.

1.

Remove the engine undercover (A).

1.

Remove the drain plug (A), and drain the ATF.

2.

Reinstall the drain plug using a new sealing washer (B).

1.

Remove the shift solenoid valve cover (A) with the dowel pins (B), the gasket (C), and the clamp bracket (D).

1.

Disconnect the connector (A).

2.

Disconnect the connectors (A).

3.

Remove the shift solenoid wire harness (B) with the O-ring (C).

1.

Install the shift solenoid wire harness (E) using a new O-ring (F).

2.

Connect the shift solenoid valve connectors:

3.

Check the connector (A) for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.

1.

Install the shift solenoid valve cover (A) with the dowel pins (B), a new gasket (C), and the clamp bracket (D).

1.

Remove the ATF dipstick (yellow loop) (A), and wipe it with a clean cloth.

3.

Insert the ATF dipstick (A) back into the dipstick hole.

4.

Remove the dipstick.

5.

Make sure the fluid level is between the upper mark (B) and the lower mark (C) on the dipstick.

6.

Insert the dipstick back into the dipstick hole.

1.

Install the engine undercover (A).

1.

After doing all procedures, select the individual maintenance item you wish to reset with the HDS..