Honda Civic manuals

Honda Civic Service Manual: Power Window Master Switch Removal and Installation (4-door)

Honda Civic Service Manual / Body / Doors and Enclosures / Doors / Power Window Master Switch Removal and Installation (4-door)

Removal

1. Front Door Power Window Switch Panel (4-door)

1.

Remove the power window switch panel (A).
2. Front Door Power Window Switch - Driver's Side

1.

Remove the power window master switch (A).

Installation

1. Front Door Power Window Switch - Driver's Side

1.

Install the power window master switch (A).
2. Front Door Power Window Switch Panel (4-door)

1.

Install the power window switch panel (A).
3. Power Window Control Unit - Reset

Resetting the power window is required when any of the following have occurred:

Power window regulator replacement or repair

Power window motor replacement or repair

Glass run channel replacement

Driver's door glass replacement

Power window master switch replacement

1.

Turn the ignition switch to ON (II).

2.

Move the driver's window all the way down with the driver's window DOWN switch.

3.

Open the driver's door.

NOTE: Steps 4-7 must be done within 5 seconds of each other.

4.

Turn the ignition switch to LOCK (0).

armounupnwlrwindnwdawdawnswiich

5.

Push and hold the driver's window DOWN switch.

6.

Turn the ignition switch to ON (II).

7.

Release the driver's window DOWN switch.

8.

Repeat step 4-7 three more times.

9.

Wait at least 1 second.

10.

Confirm that AUTO UP and AUTO DOWN do not work. If AUTO UP and DOWN work, go back to step 1.

11.

Move the driver's window all the way down with the driver's window DOWN switch.

12.

Pull up and hold the driver's window UP switch until the window reaches the fully closed position, then continue to hold the switch for at least 1 second.

13.

Confirm that the power window control unit is reset by using the driver's window AUTO UP and AUTO DOWN functions:

If the window still does not work in AUTO, repeat the procedure several times, paying close attention to the 5 second time limit between steps.

If the window still does not work, refer to the master switch input test.
Power Mirror Switch Removal and Installation (2-door)
744150 Removal 1. Front Door Panel (2-Door) 1. Remove the i ...

Quarter Pillar Trim Removal and Installation (2-door)
Removal SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. ...

See also:

Honda Civic Owners Manual. HFL Menus
The ignition switch must be in ACCESSORY (q or ON (w*1 to use HFL. Phone settings screen *1: Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch. HFL Menus To use HFL, you must first pair your Bluetoothcompatible cell phon ...

© 2016-2025 Copyright www.hocivic.com

0.0192