Driving through standing water or flooded sections of road can cause substantial damage to your Seat Ibiza, particularly if water reaches sensitive mechanical or electrical components. Whenever possible, choose an alternative route rather than attempting to cross a flooded area. If driving through water cannot be avoided and conditions allow a safe crossing, observe the following precautions:
WARNING After driving through flooded areas, the braking performance of your Seat Ibiza may be temporarily reduced because water can remain on the brake discs and pads. Damp braking components may provide less effective braking until they have dried, potentially increasing the stopping distance. Once clear of the water, check the brakes carefully under safe driving conditions and allow sufficient distance from other vehicles until normal braking effectiveness has been restored.
Note
Running in
New mechanical components require an initial period of careful operation to allow their moving surfaces to settle into their normal working condition. Following the recommended running-in procedures helps promote reliable performance, reduce unnecessary wear and support the long-term durability of your Seat Ibiza. Pay particular attention to the instructions for the engine and other newly fitted components.
Running-in the engine
A new engine requires a running-in period covering approximately the first 1500 kilometres (1000 miles) of operation. During the initial hours of use, friction between internal moving components is higher than it will be once the contacting surfaces have gradually settled and become properly bedded in. For this reason, the engine should not be subjected to excessive loads or unnecessarily high rotational speeds during its early service life.
The way your Seat Ibiza is driven during the first 1500 km (1000 miles) can influence the engine's subsequent performance, efficiency and long-term reliability. Careful acceleration, appropriate gear selection and gradual increases in engine load allow the mechanical components to adapt progressively to normal operating conditions.
Throughout the vehicle's service life, moderate driving habits are recommended, particularly when the engine has not yet reached its normal operating temperature. Avoid placing heavy demands on a cold engine, as doing so can increase mechanical wear and shorten its useful life. Equally, do not operate the engine at excessively low speeds under load. If the engine begins to run unevenly, vibrate or struggle because the selected gear is too high, change to a lower gear promptly to restore smooth operation and prevent unnecessary strain on the drivetrain.
During the first 1000 km (approximately 600 miles), observe the following restrictions to protect the new engine while its internal components are running in:
Between 1000 and 1500 kilometres (approximately 600 to 1000 miles), engine load and rotational speed may be increased gradually. Progressively introduce higher engine speeds and greater power demands until the full operating range can be used. Avoid moving abruptly from gentle running-in conditions to prolonged maximum-load operation. A progressive transition helps the engine complete its running-in process under controlled conditions.
Running in new tyres and brake pads
For the sake of the environment
Running in the engine gently and avoiding excessive loads during its initial service period can contribute to a longer engine life and lower engine oil consumption. Smooth acceleration, sensible engine speeds and careful driving habits also help reduce unnecessary fuel consumption and mechanical wear throughout the operating life of your Seat Ibiza.
Driving with a loaded vehicle
Trips abroadHonda Civic Owners Manual. Overheating
How to Handle Overheating
Overheating symptoms are as follows:
The temperature gauge pointer is at the H mark or the engine
suddenly loses
power.
Steam or spray comes out of the engine compartment.
First thing to do
Immediately park the vehicle in a safe pl ...