Honda Civic Service Manual: Crankshaft Pilot Bushing Inspection (R18Z1 M/T)

Removal

|
|
1.
|
Install the ring gear holder.
|
|
2.
|
Install the clutch alignment shaft and the remover handle.
|
|
3.
|
To prevent warping, loosen the pressure plate mounting bolts
(A) in a crisscross pattern in several steps.
|
|
4.
|
Remove the pressure plate (B).
|
|

|
|
1.
|
Remove the clutch disc (A), the clutch alignment shaft, and the
remover handle.
|
|
Inspection
1. |
Crankshaft Pilot Bushing Inspection |

|
|
1.
|
Inspect the crankshaft pilot bushing for wear and damage.
|
|
2.
|
Inspect the inside surface of the crankshaft pilot bushing with
your finger. If the crankshaft pilot bushing is not smooth, replace
it.
|
|

Installation
(pm
|
|
1.
|
Temporarily install the clutch disc onto the splines of the transmission
mainshaft. Make sure the clutch disc slides freely on the mainshaft.
|
|
2.
|
Apply super high temp urea grease (P/N 08798-9002) to the splines
(A) of the clutch disc (B).
|
|
NOTE: Wipe off any excess grease.
|
|
3.
|
Install the clutch disc using the clutch alignment shaft and
the remover handle.
|
|

|
|
1.
|
Install the pressure plate (A) and the mounting bolts (B) finger-tight.
|
|
a7aag-suaa1aa
|
|
2.
|
Torque the pressure plate mounting bolts (A) in a crisscross
pattern.
|
|
NOTE:
|
|

|
Tighten the bolts in several steps to prevent
warping the diaphragm spring.
|
|
|

|
Make sure that there is no clearance between
the pressure plate and the flywheel.
|
|
|
|
Specified Torque:
|
25 N·m (2.5 kgf·m, 18 lbf·ft)
|
|
|
|
|
3.
|
Remove the ring gear holder.
|
|
4.
|
Remove the clutch alignment shaft and the remover handle.
|
|
5.
|
Make sure the diaphragm spring fingers are all the same height.
|
|
Removal
1.
Pressure Plate
1.
Install the ring gear holder.
2.
...
Removal
1.
Pressure Plate
1.
Install the ring gear holder.
2.
...
See also:
Honda Civic Owners Manual. Checking the Engine
If the engine does not start, check the starter.
Checking the Engine
If you must start the vehicle immediately, use an
assisting vehicle to jump start it.
Starter condition
Checklist
Starter doesn't turn or turns
over slowly.
The batte ...