Information about the brakes
New brake pads require a running-in period of approximately 200 to 300 km before they achieve their full braking performance. During this initial period, the friction surfaces of the pads gradually adapt to the brake discs, and the braking system may not respond as effectively as it will once the components have properly settled. As a result, the stopping distance during emergency braking may be longer than with fully bedded-in brake pads. When driving a Seat Ibiza with new brake pads, avoid unnecessary hard braking and situations that place excessive demands on the braking system. Maintain a greater distance from the vehicle ahead, anticipate changes in traffic conditions and brake progressively whenever possible. These precautions are particularly important during the first few hundred kilometres, when the braking characteristics are still developing.
The rate at which brake pads wear depends largely on driving habits, road conditions and how frequently the braking system is used. Repeated braking in congested city traffic, frequent short journeys and a sporty driving style can accelerate brake pad wear compared with more consistent driving at moderate speeds. Vehicles regularly operated under these conditions may require more frequent inspections of the braking components. If your Seat Ibiza is used primarily for urban journeys, stop-and-go traffic or driving that involves frequent heavy braking, arrange for the brake pad thickness to be checked regularly by a qualified specialist workshop. Monitoring pad wear helps identify when replacement is necessary and reduces the risk of damage to other braking components.
Braking effectiveness can be temporarily reduced when the brake discs and pads become wet. This may occur after driving through standing water, travelling in heavy rain or washing the vehicle. Moisture between the friction surfaces can reduce the initial braking response, meaning that the driver may need to apply greater pressure to the brake pedal to achieve the desired deceleration. During winter, moisture on the brake discs may also freeze, further affecting braking performance until the affected surfaces are cleared. After exposure to water or freezing conditions, be prepared for a change in braking response and allow additional stopping distance. When traffic conditions permit, carefully applying the brakes can help remove moisture from the braking surfaces and restore normal effectiveness.
A layer of road salt on the brake discs and pads can also impair the braking performance of the Seat Ibiza. Salt deposits may accumulate on the friction surfaces during winter driving, particularly when roads have been treated to prevent ice formation. If these deposits remain between the brake pads and discs, the brakes may initially provide less friction than expected, increasing the distance required to stop the vehicle. The driver should therefore be aware that braking response may be reduced even when the braking system is otherwise functioning correctly.
When travelling on roads treated with salt, especially after driving for an extended period without using the brakes, it is advisable to remove accumulated deposits by applying the brake pedal gently several times. These controlled braking applications help clear salt from the contact surfaces and restore a more consistent braking response. Perform this procedure only when the surrounding traffic and road conditions allow it, ensuring that the vehicle can be slowed safely without causing inconvenience or danger to other road users. Avoid abrupt braking solely for the purpose of cleaning the discs.
Brake disc corrosion and contamination of the brake pads are more likely to develop when a vehicle remains parked for an extended period or is driven only occasionally over short distances. Under these conditions, moisture and environmental deposits may remain on the braking surfaces instead of being removed through regular brake operation. Surface corrosion can cause changes in braking response and may affect the smoothness of braking until the discs have been cleaned. If corrosion is present, the manufacturer recommends cleaning the brake discs and pads by applying the brakes firmly several times while travelling at a relatively high speed. This should only be attempted in suitable road and traffic conditions, with sufficient space to carry out the braking manoeuvres safely. If braking performance remains abnormal or the corrosion appears significant, the braking system should be inspected by a specialist workshop rather than relying on repeated braking to correct the problem.
Before carrying out any braking manoeuvre intended to dry or clean the braking system, make sure that it will not create a hazard for other vehicles, pedestrians or road users. Check the traffic situation carefully, maintain adequate distance from following vehicles and avoid unexpected deceleration. The need to restore brake performance must never take priority over the immediate safety of the occupants of the Seat Ibiza or other people using the road.
WARNING Driving with excessively worn brake pads or a defective braking system can seriously compromise the ability to slow down or stop the Seat Ibiza. Reduced braking effectiveness, unpredictable brake response or mechanical failure can increase stopping distances and lead to loss of vehicle control. Continuing to operate a vehicle with known brake defects creates a significant risk of accidents and serious injuries, particularly during emergency braking or when driving in demanding conditions.
WARNING New brake pads do not provide their maximum braking performance immediately after installation. Their friction surfaces require a running-in period before they can deliver the normal braking response expected from a fully bedded-in braking system. During this period, the Seat Ibiza may require a greater braking effort or a longer distance to stop, especially when sudden or intensive braking is necessary. The driver must take these temporary limitations into account and adapt driving behaviour accordingly.
WARNING Overheated brakes can lose a significant amount of their braking effectiveness, increasing the distance required to slow down or stop the Seat Ibiza. Excessive heat reduces the ability of the braking system to respond consistently, particularly when the brakes are used repeatedly or continuously under heavy load. This can make it more difficult to control the vehicle and considerably increase the risk of an accident.
Using engine braking reduces the amount of work required from the service brakes and helps limit the build-up of heat in the braking components. Choose a gear appropriate to the gradient and vehicle speed, and use the brake pedal whenever additional deceleration is necessary. Do not wait until the brakes have become overheated before reducing speed.
Also observe the relevant information concerning brake fluid, as the condition and properties of the fluid are important for reliable braking performance. Excessive brake temperatures can affect the operation of the braking system, making proper maintenance and unobstructed cooling essential.
WARNING Wet, frozen or salt-contaminated brakes may respond less effectively than brakes with clean, dry friction surfaces. Moisture, ice or road salt between the brake pads and discs can reduce the initial braking effect, meaning that greater pedal pressure or a longer stopping distance may be required. This temporary reduction in performance can be especially dangerous when the driver needs to brake suddenly or when road conditions already provide limited traction.
WARNING During certain automatically initiated braking operations, the brake pedal may move towards the applied position without the driver pressing it. This movement is a result of the braking system operating automatically and must not be obstructed. Never place your foot underneath the brake pedal or allow any part of your body to interfere with its movement. If the pedal moves automatically while your foot is positioned beneath it, there is a risk of injury. Always keep the area around the brake pedal clear so that it can move freely whenever the braking system is activated.
Note Do not allow the brakes to drag by resting your foot on the brake pedal when braking is not required. Even light, continuous pressure may cause the brake pads to remain in contact with the discs, generating unnecessary friction and heat while the Seat Ibiza is moving. Over time, this can accelerate brake pad and disc wear, reduce braking effectiveness and increase the brake pedal travel required to achieve the desired deceleration. Remove your foot from the brake pedal whenever you are not intentionally slowing or stopping the vehicle. Also observe the important maintenance and safety information relating to brake fluid, as its condition can influence the reliability of the braking system.
Note Check the thickness of the brake pads regularly to monitor their condition and identify excessive wear before braking performance is affected. Depending on the wheel design and accessibility, the pads may be inspected visually through openings in the wheel rims or from underneath the vehicle. However, these viewing positions may not provide a complete picture of the condition of every brake pad. If a more thorough inspection is required, the wheels may need to be removed so that the friction material can be examined properly. SEAT recommends having these checks performed by an authorised SEAT dealership, where the braking components can be inspected and their condition assessed by qualified personnel.
Troubleshooting
Defect in the brake system
If the braking system detects a serious malfunction, the corresponding warning lamp illuminates red on the Seat Ibiza instrument cluster. An additional warning message may also appear on the display, providing further information about the fault. A red brake system warning indicates a potentially dangerous condition that may affect the vehicle's ability to slow down or stop safely. Do not assume that the braking system is functioning normally simply because some braking effect remains available.
Stop driving!
Selecting a drive profileHonda Civic Owners Manual. Playing Pandora’
Your audio system allows you to listen to music from the Pandora’ app on a
compatible smartphone.
This function is available when the phone is paired and connected to the
vehicle’s
Bluetooth’ HandsFreeLink’ (HFL) system, or with an iPhone, you can connect using
your USB cable to the ...