Honda Civic Service Manual: Transmission End Cover Selector Control Shaft Oil Seal Replacement (A/T)
2321H3
|
|
1.
|
Raise the vehicle on a lift, and make sure it is securely supported.
|
|
|
1.
|
Remove the splash shield (A).
|
| 3. |
Transmission Range Switch Cover |
|
|
|
1.
|
Remove the transmission range switch cover (A).
|
|
| 4. |
Transmission Range Switch |
|
|
|
1.
|
Disconnect the connector (A).
|
|
2.
|
Remove the transmission range switch (B).
|
|
| 5. |
Selector Control Shaft Oil Seal |
|
|
|
1.
|
Remove the selector control shaft oil seal (A).
|
|
| 1. |
Selector Control Shaft Oil Seal |
|
|
|
1.
|
Install the selector control shaft oil seal (A) flush with the
end cover using the 22 x 24 mm attachment.
|
|
| 2. |
Transmission Range Switch |
|
|
|
1.
|
Make sure the selector control shaft is in the N position. If
necessary, move the selector control shaft to the N position.
|
|
NOTE: Do not use the selector control shaft to adjust the shift
position. If the selector control shaft tips are squeezed together
it will cause a faulty signal or position due to play between the
selector control shaft and switch.
|
|
|
|
|
2.
|
Align the cutouts (A) on the rotary-frame with the neutral positioning
cutouts (B) on the transmission range switch (C), then put a 2.0
mm (0.079 in) feeler gauge blade (D) in the cutouts to hold the
switch in the N position.
|
|
NOTE: Be sure to use a 2.0 mm (0.079 in) blade or equivalent
to hold the switch in the N position.
|
|
|
|
|
3.
|
Install the transmission range switch (A) gently on the selector
control shaft (B) while holding it in the N position with the 2.0
mm (0.079 in) blade (C).
|
|
|
|
|
4.
|
Tighten the bolts on the transmission range switch (A) while
you continue holding the N position.
|
|
NOTE: Do not move the transmission range switch when tightening
the bolts.
|
|
5.
|
Remove the feeler gauge (B).
|
|
6.
|
Check the connector (C) for corrosion, dirt, or oil, and clean
or repair if necessary, then connect the connector securely.
|
|
| 3. |
Transmission Range Switch Cover |
|
 mmnm
|
|
1.
|
Install the transmission range switch cover (A).
|
|
|
1.
|
Install the splash shield (A).
|
2221A3 FRONT
1.
Vehicle Lift
1.
Raise the vehicle on a lift, and make sure it is securely supported.
...
NOTE: Do not hold the shift solenoid valve connector to remove the shift
solenoid valves. Be sure to hold the shift solenoid valve body.
1.
Vehicle Lift
...
See also:
Honda Civic Owners Manual. Reporting Safety Defects
In the U.S.
If you believe that your vehicle has a defect which could cause a crash or could
cause injury or death, you
should immediately inform the National Highway Traffic Safety Administration (NHTSA)
in addition to
notifying American Honda Motor Co., Inc.
If NHTSA receives similar c ...
Transmission Fluid Pressure Switch B (3rd Clutch) Removal and Installation (A/T)
Shift Solenoid Valve Removal and Installation (A/T)