Honda Civic Service Manual: Transmission End Cover Selector Control Shaft Oil Seal Replacement (A/T)

1.

Raise the vehicle on a lift, and make sure it is securely supported.

1.

Remove the transmission range switch cover (A).

1.

Disconnect the connector (A).

2.

Remove the transmission range switch (B).

1.

Remove the selector control shaft oil seal (A).

1.

Install the selector control shaft oil seal (A) flush with the end cover using the 22 x 24 mm attachment.

1.

Make sure the selector control shaft is in the N position. If necessary, move the selector control shaft to the N position.

NOTE: Do not use the selector control shaft to adjust the shift position. If the selector control shaft tips are squeezed together it will cause a faulty signal or position due to play between the selector control shaft and switch.

2.

Align the cutouts (A) on the rotary-frame with the neutral positioning cutouts (B) on the transmission range switch (C), then put a 2.0 mm (0.079 in) feeler gauge blade (D) in the cutouts to hold the switch in the N position.

NOTE: Be sure to use a 2.0 mm (0.079 in) blade or equivalent to hold the switch in the N position.

3.

Install the transmission range switch (A) gently on the selector control shaft (B) while holding it in the N position with the 2.0 mm (0.079 in) blade (C).

4.

Tighten the bolts on the transmission range switch (A) while you continue holding the N position.

NOTE: Do not move the transmission range switch when tightening the bolts.

5.

Remove the feeler gauge (B).

6.

Check the connector (C) for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.

1.

Install the transmission range switch cover (A).