Honda Civic Service Manual: Alternator Removal and Installation (Except K24Z7)

1.

Make sure the ignition switch is in LOCK (0), or the vehicle ignition in the OFF mode.

2.

Disconnect and isolate the negative cable with the battery sensor (A) from the battery.

NOTE:

3.

Disconnect the positive cable (D) from the battery.

1.

Move the auto-tensioner (A) counterclockwise to relieve tension from the drive belt (B).

2.

Remove the drive belt.

1.

Disconnect the connector and the cable.

2.

Remove the harness connector (A) and the harness clamps (B).

3.

Remove the alternator.

1.

Install the alternator.

2.

Connect the connector and the cable. Make sure the crimped side of the ring terminal faces away from the alternator when you connect it.

3.

Install the harness connector (A) and the harness clamps (B).

1.

Move the auto-tensioner (A) counterclockwise.

2.

Install the drive belt (B).

NOTE: If the battery performs abnormally, test the battery.

1.

Clean the battery terminals.

2.

Connect the positive cable (A) to the battery.

NOTE: Always connect the positive side first.

3.

Connect the negative cable and the battery sensor (B) to the battery.

NOTE: To protect the battery sensor connector (C) from damage, do not hold it when installing the negative terminal.

4.

Apply multipurpose grease to the terminals to prevent corrosion.