Honda Civic manuals

Honda Civic Service Manual: Connecting Rod Bolt Inspection (Except K24Z7)

Honda Civic Service Manual / Powertrain / Engine / Engine Block / Cylinder Block / Connecting Rod Bolt Inspection (Except K24Z7)

Inspection

1. Connecting Rod Bolt - Inspection

1.

Measure the diameter of each connecting rod bolt at point A and point B.


:5mmzommin)


2.

Calculate the difference in diameter between point A and point B.


Point A-Point B = Difference in Diameter

Difference in Diameter

Specification:

0-0.1 mm (0-0.004 in)


3.

If the difference in diameter is out of specification, replace the connecting rod bolt.


Connecting Rod Bearing Replacement (R18Z1)
Removal 1. Intake Manifold and Throttle Body Assembly 1. Remove the intake air duct. ...

Connecting Rod Bolt Inspection (K24Z7)
Inspection 1. Connecting Rod Bolt - Inspection 1. Measure the diameter of each connecting rod bolt at point A and point B. 35mmzomm ...

See also:

Honda Civic Service Manual. Side Impact Sensor (First) Removal and Installation (2-door)
7521B6 LEFT FRONT 7521B7 RIGHT FRONT Removal NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. 1. Battery Termi ...

© 2016-2023 Copyright www.hocivic.com

0.1174