Honda Civic Service Manual: Power Window Master Switch Removal and Installation (4-door)
Removal
| 1. | Front Door Power Window Switch Panel (4-door) |
|
|
|
| 2. | Front Door Power Window Switch - Driver's Side |
|
|
|
Installation
| 1. | Front Door Power Window Switch - Driver's Side |
|
|
|
| 2. | Front Door Power Window Switch Panel (4-door) |
|
|
|
| 3. | Power Window Control Unit - Reset |
|
Resetting the power window is required when any of the following have occurred: |
|
|||
|
|||
|
|||
|
|||
|
|
1. |
Turn the ignition switch to ON (II). |
|
2. |
Move the driver's window all the way down with the driver's window DOWN switch. |
|
3. |
Open the driver's door. |
|
|
NOTE: Steps 4-7 must be done within 5 seconds of each other. |
||
|
4. |
Turn the ignition switch to LOCK (0). |
armounupnwlrwindnwdawdawnswiich
|
5. |
Push and hold the driver's window DOWN switch. |
|
6. |
Turn the ignition switch to ON (II). |
|
7. |
Release the driver's window DOWN switch. |
|
8. |
Repeat step 4-7 three more times. |
|
9. |
Wait at least 1 second. |
|
10. |
Confirm that AUTO UP and AUTO DOWN do not work. If AUTO UP and DOWN work, go back to step 1. |
|
11. |
Move the driver's window all the way down with the driver's window DOWN switch. |
|
12. |
Pull up and hold the driver's window UP switch until the window reaches the fully closed position, then continue to hold the switch for at least 1 second. |
|
13. |
Confirm that the power window control unit is reset by using the driver's window AUTO UP and AUTO DOWN functions: |
|||||||||
|
||||||||||
Power Mirror Switch Removal and Installation (2-door)
744150
Removal
1.
Front Door Panel (2-Door)
1.
Remove the i ...
Quarter Pillar Trim Removal and Installation (2-door)
Removal
SRS components are located in this area. Review the SRS component
locations and the precautions and procedures before doing repairs
or service.
...
See also:
Honda Civic Owners Manual. Smart Entry Remote Reminder
Warning buzzers may sound from inside and/
or outside the vehicle to remind you that the
smart entry remote is out of the vehicle. If the
buzzer continues even after the remote is put
back inside, place it within the system’s
operational range.
When the power mode is in ON
If the smart ...
