Honda Civic manuals

Honda Civic Service Manual: Fuel Fill Door Switch Removal and Installation (Natural Gas models)

Honda Civic Service Manual / Body / Doors and Enclosures / Fuel/Charge Lid / Fuel Fill Door Switch Removal and Installation (Natural Gas models)

1. Vehicle Lift

1.

Raise the vehicle on a lift, and make sure it is securely supported.
2. Rear Wheel

1.

Remove the rear wheel.
3. Fuel Pipe Protector (Natural Gas Model)

1.

Remove the fuel filler pipe protector (A).
4. Trunk Floor Lid (Natural Gas Model)

1.

Remove the trunk floor cover (A).
5. Trunk Lid Weatherstrip as Needed

1.

Remove the trunk lid weatherstrip (A) as needed.
6. Trunk Rear Trim Panel (Natural Gas Model)

1.

Remove the trunk rear trim panel (A).
7. Trunk Front Trim Panel (Natural Gas Model)

1.

Remove the trunk front trim panel (A) and the trunk partition (B) as an assembly.
8. Trunk Side Trim Panel (Natural Gas Model)

1.

Remove the trunk side trim panel (A).
9. Fuel Fill Door Switch (Natural Gas Model)

1.

From the trunk compartment, disconnect the fuel fill door switch connector (A), and detach the harness clip (B).

2.

Open the fuel fill door, release the fuel fill door switch (A) by turning it 90 ° from the fuel receptacle adapter (B).

3.

From the wheel arch, remove the clip (A) and the grommet (B), then remove the fuel fill door switch (C) out through the hole in the body.

1. Fuel Fill Door Switch (Natural Gas Model)

1.

From the wheel arch, install the clip (A).

2.

Insert the fuel fill door switch (B) into the hole in the body and the grommet (C).

NOTE: Align the marks (D) on the fuel fill door switch with the grommet as shown.

3.

Set the fuel fill door switch (A) by turning it 90 ° to the fuel receptacle adapter (B).

4.

From the trunk compartment, install the harness clip (A) and connect the fuel fill door switch connector (B).
2. Trunk Side Trim Panel (Natural Gas Model)

1.

Install the trunk side trim panel (A).
3. Trunk Front Trim Panel (Natural Gas Model)

1.

Install the trunk front trim panel (A) and the trunk partition (B) as an assembly.
4. Trunk Rear Trim Panel (Natural Gas Model)

1.

Install the trunk rear trim panel (A).
5. Trunk Lid Weatherstrip as Needed

1.

Install the trunk lid weatherstrip (A).
6. Trunk Floor Lid (Natural Gas Model)

1.

Install the trunk floor cover (A).
7. Fuel Pipe Protector (Natural Gas Model)

1.

Install the fuel filler pipe protector (A).
8. Rear Wheel

15mmumum

1.

Install the rear wheel.

NOTE: Before installing the wheel, clean the mating surfaces between the brake disc or the brake drum and the inside of the wheel.
Fuel/Charge Lid
...

Trunk Lid Opener Cable/Fuel Fill Door Opener Cable Removal and Installation (4-door except Natural Gas models)
823160 SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. ...

See also:

Honda Civic Owners Manual. Housing Locations
The front airbags are housed in the center of the steering wheel for the driver, and in the dashboard for the front passenger. Both airbags are marked SRS AIRBAG. *1: Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch. Front Airbags (SRS) Dual- ...

© 2016-2022 Copyright www.hocivic.com

0.1391