Honda Civic Service Manual: Front Fog Light Removal and Installation ('13-'14: 4-door)
Except Si model
Si model
|
|
1.
|
Remove the front fog light trim (A).
|
|
Except Si model
Si model
|
|
1.
|
Remove the front fog light (A).
|
|
2.
|
Disconnect the connector.
|
|
Except Si model
Si model
|
|
1.
|
Connect the connector.
|
|
2.
|
Install the front fog light (A).
|
|
Except Si model
Si model
|
|
1.
|
Install the front fog light trim (A).
|
|
3. |
Front Fog Light - Adjustment |
|
Before adjusting the front fog light:
|
|
|
Park the vehicle on a level surface.
|
|
|
|
Make sure the tire pressures are correct
|
|
|
|
The driver or someone who weights the same should
sit in the driver's seat (or an equivalent amount
of weight).
|
|
|
|
Unload the vehicle.
|
|
The front fog lights should aim down slightly. To check
for proper adjustment:
|
|
1.
|
Park the vehicle in front of a wall or a screen (A).
|
|
2.
|
Turn the front fog lights on.
|
|
3.
|
Determine if the front fog lights are aimed properly:
|
|
|
Measure the height of the front fog lights
(B).
|
|
|
|
On the screen or wall, mark the height
of the front fog lights with a piece of
tape (C).
|
|
|
|
With the vehicle parked 3 m (9.8 ft)
from the screen, the top of the front fog
light beam should be 4.5 cm (1.77 in) (D)
below the tape mark.
|
|
|
|
Except Si model
Si model
|
|
4.
|
Adjust the front fog lights by turning the adjuster (A).
|
|
019106 LEFT
019107 RIGHT
Removal
1.
Front Fog Light Assembly
1.
...
1.
Front Bumper
1.
Remove the screws (A), the bolts (B), and the c ...
See also:
Honda Civic Owners Manual. Supplemental Restraint System (SRS) Indicator
When the ignition switch is turned to
ON *1
The indicator comes on for a few seconds,
then goes off. This tells you the system is
working properly.
If the indicator comes on at any other time, or does not come on at all, have
the
system checked by a dealer as soon as possible. If you don ...