Honda Civic manuals

Honda Civic Service Manual: Flywheel Removal and Installation (R18Z1 M/T)

Honda Civic Service Manual / Powertrain / Transmission/Transaxle / Manual / Flywheel Removal and Installation (R18Z1 M/T)

210101

Removal

1. Pressure Plate


1.

Install the ring gear holder.


2.

Install the clutch alignment shaft and the remover handle.


3.

To prevent warping, loosen the pressure plate mounting bolts (A) in a crisscross pattern in several steps.


4.

Remove the pressure plate (B).


2. Clutch Disc

1.

Remove the clutch disc (A), the clutch alignment shaft, and the remover handle.


3. Flywheel

n7lab-wnolun


1.

Remove the flywheel (A).


NOTE: Loosen the flywheel mounting bolts (B) in a crisscross pattern in several steps.


2.

Remove the ring gear holder.


Installation

1. Flywheel


1.

Install the flywheel (A) on the crankshaft, and install the mounting bolts (B) finger-tight.


2.

Install the ring gear holder.


:2minn-inno

3.

Tighten the flywheel mounting bolts (A) in a crisscross pattern in several steps.


2. Clutch Disc

(pm


1.

Temporarily install the clutch disc onto the splines of the transmission mainshaft. Make sure the clutch disc slides freely on the mainshaft.


2.

Apply super high temp urea grease (P/N 08798-9002) to the splines (A) of the clutch disc (B).


NOTE: Wipe off any excess grease.


3.

Install the clutch disc using the clutch alignment shaft and the remover handle.


3. Pressure Plate

1.

Install the pressure plate (A) and the mounting bolts (B) finger-tight.


a7aag-suaa1aa


2.

Torque the pressure plate mounting bolts (A) in a crisscross pattern.


NOTE:

Tighten the bolts in several steps to prevent warping the diaphragm spring.

Make sure that there is no clearance between the pressure plate and the flywheel.


Specified Torque:

25 N·m (2.5 kgf·m, 18 lbf·ft)


3.

Remove the ring gear holder.


4.

Remove the clutch alignment shaft and the remover handle.


5.

Make sure the diaphragm spring fingers are all the same height.


Engine Removal and Installation (R18Z1 (A/T, M/T))
11010A 1. Vehicle Lift 1. Raise the vehicle on a lift, and make sure it is securely supported. ...

Front Driveshaft Disassembly and Reassembly (A/T, M/T)
1. Front Driveshaft Exploded View Exploded View looponly!mboaldsslusegreasemcludedmhaardhamlowampsnvmwucdamperwwstopringlowearrehlace.lhglnasn...oumaam ...

See also:

Honda Civic Owners Manual. Rear Defogger/Heated Door Mirror* Button
Press the rear defogger and heated door mirror button to defog the rear window and mirrors when the ignition switch is in ON *1. The rear defogger and heated door mirrors automatically switch off after 10-30 minutes depending on the outside temperature. However, if the outside temperat ...

© 2016-2024 Copyright www.hocivic.com

0.0179