Honda Civic manuals

Honda Civic Service Manual: Battery Terminal Removal and Installation

Honda Civic Service Manual / Electrical / Battery System / Battery Terminal Removal and Installation

Removal

1. Battery Terminal - Disconnection


1.

Make sure the ignition switch is in LOCK (0).


2.

Disconnect and isolate the negative cable and battery sensor (A) from the battery.


NOTE: Always disconnect the negative cable from the battery first.


3.

Disconnect the positive cable (B) from the battery positive terminal (C).


2. Battery Positive Terminal

1.

Remove the battery positive terminal (A).


Installation

1. Battery Positive Terminal

1.

Install the battery positive terminal (A).


2. Battery Terminal - Reconnection


NOTE: If the battery performs abnormally, test the battery.


1.

Clean the battery terminals.


2.

Connect the positive cable (A) to the battery positive terminal (B).


NOTE: Always reconnect the positive cable to the battery first.


3.

Connect the negative cable and battery sensor (C) to the battery sensor (D).


4.

Apply multipurpose grease to the terminal to prevent corrosion.


Battery Terminal Disconnection and Reconnection
Removal 1. Battery Terminal - Disconnection 1. Make sure the ignition switch is in LOCK (0). ...

Charging
...

See also:

Honda Civic Owners Manual. Traction
The traction grades, from highest to lowest, are AA, A, B, and C. Those grades represent the tire's ability to stop on wet pavement as measured under controlled conditions on specified government test surfaces of asphalt and concrete. A tire marked C may have poor traction performance. ...

© 2016-2018 Copyright www.hocivic.com